Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 80)

Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-48
Performing soft system resets (reset modes 3, 4, and 5)
Perform a soft reset of the switcher as follows:
1 . Use an Extron Tweeker or other small screwdriver to press and hold the rear
panel Reset button until the rear panel Reset LED and the front panel View
and Esc buttons blink once (events reset), twice (system reset), or three times
(absolute reset).
RESET
Rx
RESET RESET
RESET
Rx
RESET RESET
RESET
Rx
RESET RESET
I / O
RGBHV AUDIO
I / O
RGBHV AUDIO
I / O
RGBHV AUDIO
Front panel I/O buttons flash once.
Front panel I/O buttons flash twice.
Front panel I/O buttons flash three times.
Press and hold
the Reset button.
Release, then
immediately
press and release.
Release, then
immediately
press and release.
Release, then
immediately
press and release.
3 seconds
Events Reset
(Mode 3)
IP Settings
Reset
(Mode 4)
Reset LED
flashes
once.
1
Press and hold
the Reset button.
6 seconds
Reset LED
flashes
twice.
2
Absolute
Reset
(Mode 5)
Press and hold
the Reset button.
9 seconds
Reset LED
flashes
three
times.
3 Reset LED
flashes
four
times.
3
Reset LED
flashes
four
times.
3
Reset LED
flashes
four
times.
3
2 . Release the Reset button and then immediately press and release the Reset
button again. Nothing happens if the second momentary press does not occur
within 1 second.