Programmer’s guide, cont’d – Extron Electronics MAV Plus series Large Scale User Guide User Manual
Page 110
Programmer’s Guide, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide
4-22
Command
ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
IP setup commands
Set matrix name
EX3)
CN
}
Ipn•
X3)]
Read matrix name
E
CN
}
X3)]
Reset matrix name to factory
default
E
•CN
}
Ipn•
X3)]
Model name plus the last 3
pairs of the MAC address.
Set time and date
EX3@
CT
}
Ipt
X3@]
Read time and date
E
CT
}
X3#]
Set GMT offset
EX3$
CZ
}
Ipz
X3$]
In the command, the divider
between hours and minutes
can be either a colon or a
period. In the response, the
divider is a colon.
Example:
E
8.0CZ
}
Ipz+08:00
]
Set Daylight Saving Time
EX3%
CX
}
X3%]
Read Daylight Saving Time
E
CX
}
X3%]
Set IP address
EX3^
CI
}
Ipi
X3^]
Read IP address
E
CI
}
X3^]
Read hardware (MAC)
address
E
CH
}
X3&]
Read # of open connections
E
CC
}
X3*]
Set subnet mask
EX3^
CS
}
Ips
X3^]
Read subnet mask
E
CS
}
X3^]
Set gateway IP address
EX3^
CG
}
Ipg
X3^]
Read gateway IP address
E
CG
}
X3^]
Set administrator password
EX3(
CA
}
Ipa•
X3(]
Read administrator
password
E
CA
}
X3(]
Reset (clear) administrator
password
E
•CA
}
Ipa•
]
Set user password
EX3(
CU
}
Ipu•
X3(]
Read user password
E
CU
}
X3(]
Reset (clear) user password
E
•CU
}
Ipu•
]
Set mail server, domain
name
EX3^,X4),X3(
CM
}
Ipm
X3^,X4),X3(]
Read mail server, domain
name
E
CM
}
X3^,X4),X3(]
N
The Set e-mail recipient (CR) command sets the recipient for e-mail notifications. To turn e-mail notifications on, you
must then set the events that the switcher reports using one or more separate Set e-mail events (EM) commands (see the
next page).
Set e-mail recipient
EX4!
,
X4@
CR
}
Ipr
X4!
,
X4@,]
Example:
E
}
Ipr72,[email protected]
,]
Read e-mail recipient
EX4!
CR
}
X4@,]
Command/response table for IP-Specific SIS commands