Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 53)

3-21 CrossPoint 450 Plus and MAV Plus Switchers • Operation
Example 4: Viewing video and audio, audio only, and video only ties
In the following example, the ties in the current configuration are viewed. The
steps show the front panel indications that result from your actions.
N This example assumes that you have performed example 1, example 2, and
example 3.
1 . Clear all selections : Press and release the Esc button.
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections.
The button flashes once.
2 . Select View-only mode : Press and release the View button to enter View-only
mode. The View button lights red.
3 . Select both video and audio for viewing : If necessary, press and release the
RGBHV (CrossPoint 450 Plus switchers) or Video (MAV Plus video switchers)
button and the Audio button.
I / O
VIDEO AUDIO
1 2 3 4 5 6 7 8 9
17 18 19 20 21 22 23 24 25
49 50 51 52 53 54 55 56 57
O
U
T
P
U
T
S
Until you select an input, the buttons for all untied outputs light
amber if no inputs are tied, green if no video inputs are tied
(only audio is tied), or
red if no audio inputs are tied (only
video is tied).
Until you select an input, the buttons for all untied outputs light
amber if no inputs are tied, green if no video inputs are tied
(only audio is tied), or
red if no audio inputs are tied (only
video is tied).
Press the Audio button
to toggle on and off.
The button lights when
selected. Press the RGBHV or Video
button to toggle on and off.
The button lights when
selected.