Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 106)

Programmer’s Guide, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide 4-18
Command/response table for SIS commands (continued)
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
Lock (executive) modes
N See “Setting the front panel locks ( Executive modes)” in chapter 3, “Operation”, for more Lock mode information.
Lock all front panel functions 1X Exe1
] Enable Lock mode 1.
Lock advanced front panel
functions 2X Exe2 ] Enable Lock mode 2.
Unlock all front panel
functions 0X Exe0
] Enable Lock mode 0.
View lock status X X#]
Resets
Reset all mutes E
ZZ
}
Zpz
] Unmute all outputs.
Reset audio input levels E
ZA
}
Zpa
] Reset all audio input levels
(gain and attenuation) to 0 dB.
Reset audio output levels E
ZV
}
Zpv
] Reset all audio output
levels (volume) to 100%
(no attenuation).
Reset global presets and
names E
ZG
}
Zpg
] Clear all global presets and
their names.
Reset one global preset EX(
ZG
}
Zpg
X(]
Clear global preset
X(
.
Reset room map E ZR } Zpr ] Clear all room definitions.
Reset individual room EX1)
ZR
}
Zpr
X1)]
Delete room
X1)
.
Reset all room presets and
names E
ZP
}
Zpp
} Clear all room presets and
names.
Reset individual room
preset EX1) * X1@ ZP } Zpp X1) * X1@] Clear an individual room
preset and name.
Reset RGB delays E ZD } Zpd ] Reset all RGB delays to
0.0 seconds.
Reset whole switcher E
ZXXX
}
Zpx
] Clear all ties and presets.
Absolute reset E
ZQQQ
}
Zpq
] Similar to Reset whole
switcher
, plus clear the IP
address to 192.168.254.254
and subnet mask to
255.255.000.000.
Information requests
Information request I V X$ X X@ •A X$ X X@ T X1* U X1(]
V
X$
X
X@
= video size,
A
X$
X
X@
= audio size,
T X1* = BME type,
U
X1(
= # of BMEs in system.
Example:
(MAV 450 Plus 6448 with
a connected audio BME) I V64X48•A64X48•T2•U2 ]
This low resolution matrix
switcher (T2) has 64 video
and 64 audio inputs by 48
video and 48 audio inputs.
This is a two BME system
(a video and audio BME).
N
X@
= Output number 01 – (maximum number of outputs for your model)
X#
= Lock mode 0, 1 or 2
X$
= Input number 01 – (maximum number of inputs for your model)
X(
= Global preset # 01 – 64
X1)
= Room # (for room presets) 01 – 10 (Each can have up to 10 presets (
X1@
s) assigned.)
X1@
= Room preset # 01 – 10
X1*
= BME type 1 = wideband video 3 = sync 5 = mono audio
2 = low resolution video 4 = stereo audio
X1(
= # of connected BMEs 1 – 6