Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 123)

5-11 CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software
Sync Time to PC button
Clicking the mouse on the Sync Time to PC button causes the computer you are
operating to send its internal time to the switcher in a set time command.
Use Daylight Saving check box
Click in the Use Daylight Saving check box to turn Daylight Saving Time on and
off for North America. When Daylight Saving Time is turned on, the switcher
automatically updates its internal clock between Standard Time and Daylight
Saving Time in the spring and fall on the date that the time change occurs in North
America. When Daylight Saving Time is turned off, the switcher does not adjust its
time reference.
N For Daylight Saving Time in Europe and Brazil, refer to the "Set Daylight
Saving Time" SIS command on page 4-22.
Administrator Password and User Password fields
The Administrator Password field displays the password required to log on to the
matrix switcher via the Ethernet port with all of the administrator’s rights and
privileges. The User Password field displays the password required to log on to the
matrix switcher via the Ethernet port as a user, without all of the administrator’s
rights and privileges. Passwords are case sensitive and are limited to 12 upper-case
and lower-case alphanumeric characters.
While you are logged on as a user, both password fields are masked with asterisks
(************) as a security measure.
N Editing the Administrator Password field while connected via the Ethernet port
can immediately disconnect the user from the switcher. Extron recommends
editing this field using either serial port and protecting the Ethernet access
to this screen by assigning an administrator’s password to qualified and
knowledgeable personnel only.
N An administrator password must be created before a user password can be
created.
N The following characters are invalid in passwords:
{space} + ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
Edit either password field as follows:
1 . Click in the desired Password field. The pointer tool becomes a text cursor.
2 . Edit the case-sensitive password as desired.
3 . Press the Tab key on the keyboard or click in another field to exit the
Password field.
4 . Click the Take button to make the password change take effect.