Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 57)

3-25 CrossPoint 450 Plus and MAV Plus Switchers • Operation
Example 5: Grouping inputs and outputs
In the following example, several switcher inputs and outputs are assigned to
groups. The steps show the front panel indications that result from your actions.
1 . Clear all selections : Press and release the Esc button.
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections.
The button flashes once.
2 . Select I/O Group mode : Press and hold the Input 1 and Output 1 buttons for
approximately 2 seconds and then release the buttons.
1
1
17 18 19
1 2 3
I
N
17 18 19
1 2 3
O
U
T
Press and hold the Input 1 button and Output 1 button.
Release the Input 1 button
and Output 1 button.
Ungrouped input and
output buttons light.
2 seconds
3 . Select an I/O group : Press and release the Enter button to select group 1.
C O N T R O L
PRESET ENTER ESC VIEW
1 3 2 4
Press and release the Enter button to select group 1.
The button lights to indicate the selection.
Group #
4 . Assign inputs and outputs : Press and release the input 1 through 4 and
output 1 through 4 buttons.
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
I
N
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
O
U
T
Press and release the Input 1 through Input 4 buttons. The selected buttons light.
Press and release the Output 1 through Output 4 buttons. The selected buttons light.