Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 111)

4-23 CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide
Command/response table for IP-Specific SIS commands (continued)
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
IP setup commands (continued)
N You must have first set an e-mail recipient for the e-mail account number (
X4!
), using the Set e-mail recipient (CR)
command, before you can assign events to monitor with the Set e-mail events for recipient (EM) command (see previous
page).
Set e-mail events for
recipient EX4! , X4# , X4$ , X4$ , ... , X4$ EM }
Ipe
X4$
,
X4$
,
X4$
, ... ,
X4$]
Example: E 73,3,110000 ... 0111EM } See below.
Response description: Notify what?, inputs 1 – 64 (inputs above the matrix size are always 0) power supplies fan
Response example (for CrossPoint 450 Plus 6464):
Response:
Notify failed and fixed
3, 1 1 0 0 0 0 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
01 Input: 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 52 53 51 54 55 56 57 58 59 60 61 62 63 64 Fans
Power Supplies
E-mail input 8 status E-mail power supply and fan status Ignore input 16
0 0 0 0 0 0 0 0 1 1 1
Read e-mail events for
recipients EX4!
EM
} X4$
,
X4$
,
X4$
, ... ,
X4$]
Set DHCP on or off EX4^
DH
}
Idh
X4^] X4^
: 0 = off, 1 = on
Read DHCP on/off status E
DH
} X4^]
Set serial port parameters EX4&
*
X4*
,
X4(
,
X5)
,
X5!
CP
}
Cpn
X4&
•Ccp
X4*
,
X4(
,
X5)
,
X5!]
Read serial port parameters EX4&
CP
} X4*,X4(,X5),X5!]
Set serial port mode EX4&
*
X5@
CY
}
Cpn
X4&
•Cty
X5@] X5@
: 0 = RS-232, 1 = RS-422
N The front panel Configuration port (
X4&
= 2) is limited to the RS-232 protocol only.
Read serial port mode EX4& CY } X5@]
Set verbose mode EX5#
CV
}
Vrb
X5#]
Read verbose mode E
CV
} X5#]
Read connection’s security
level E
CK
X5$]
Configure current port
timeout E
0*
X5%
TC
}
Pti0*
X5%]
View current port timeout E
0TC
} X5%]
Configure global IP port
timeout E 1* X5% TC } Pti1* X5%]
View global IP port timeout E
1TC
} X5%]
Special Characters
The HTML language reserves certain characters for specific functions. The switcher
does not accept these characters as part of preset names, the switcher’s name,
passwords, or locally created file names.
The switcher rejects the following characters:
{space (spaces are ok for names)} + ~ , @ = ‘ [ ] { } < > ’ “ semicolon (;)
colon (:) | \ and ?.