Extron Electronics MAV Plus series Large Scale User Guide User Manual
Page 39
3-7
CrossPoint 450 Plus and MAV Plus Switchers • Operation
d
Preset button —
The Preset button has two primary functions (•) and three
secondary (❏) functions:
• Activates Save Preset mode to save a configuration as a preset and Recall
Preset
mode to activate a previously-defined preset.
• Blinks when Save Preset mode is active and lights steadily when Recall
Preset
mode is active.
❏
In the I/O Group mode, selects group 2 and indicates the selection. See
"I/O grouping" on page 3-23.
❏
With the Enter, View, and Esc buttons, selects Serial Port Configuration
mode. See "Selecting the rear panel Remote port protocol and baud rate"
on page 3-46.
❏
Selects 19200 baud for the RS-232/RS-422 port in Serial Port Configuration
mode and indicates the selection. See "Selecting the rear panel Remote
port protocol and baud rate" on page 3-46.
e
View (
<
) button —
The View (
<
) button has one primary function (•) and six
secondary (❏) functions:
• Selects and indicates View-only mode, which displays the current
configuration.
N
View-only mode also provides a way to mute and unmute the outputs. See
"Muting and unmuting outputs" on page 3-32.
❏
In the I/O Group mode, selects group 3 and indicates the selection. See
"I/O grouping" on page 3-23.
❏
(Systems with CrossPoint 450 Plus Wideband switcher BMEs)
Decreases the RGB delay of switches to the selected output. See "Setting
RGB delay (systems with wideband BMEs)" on page 3-27.
❏
(Systems with audio BMEs) Decreases the audio level of the selected
input. See "Viewing and adjusting the input audio level (systems with
audio BMEs)" on page 3-35.
❏
(Systems with audio BMEs) Decreases the volume of the selected
output. See "Viewing and adjusting the output volume (systems with
audio BMEs)" on page 3-38.
❏
With the Enter, Preset, and Esc buttons, selects Serial Port Configuration
mode. See "Selecting the rear panel Remote port protocol and baud rate"
on page 3-46.
❏
Selects 38400 baud for the RS-232/RS-422 port in Serial Port Configuration
mode and indicates the selection. See "Selecting the rear panel Remote
port protocol and baud rate" on page 3-46.