Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 60)

Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-28
2 . Enter RGB Delay mode : Press and hold the RGBHV button for
approximately 2 seconds until it blinks.
RGBHV RGBHV
Press and hold the RGBHV
button until it blinks.
2 seconds
3 . Select an output : Press and release the Output 17 button.
17 18 19
1 2 3
O
U
T
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
26
10
27
11
I
N
Press and release the
Output 17 button.
The button lights.
The Input 1 through Input 10 buttons display the selected output's RGB delay.
Each lit input button indicates 0.5-second of delay.
In this example, the lit input buttons display 3.5 seconds of RGB delay.
3.5 3.0 2.5 2.0 1.5 1.0 0.5
N The RGB delay is protected when front panel lock mode 2 is selected. You
can view the delay in lock mode 2, but not change it from the front panel. See
“Setting the front panel Locks ( Executive modes)” on page 3-43.
If front panel lock mode 2 is selected and you try to perform step 4, the actions
are ignored and the Enter, RGBHV, and Audio buttons flash.
4 . Increase the delay : Press and release the Esc ( > ) button once to increase the
RGB delay by a half second.
Press and release the Esc ( > ) button twice more to increase the RGB delay by
a whole second. Note the input button indications that change each time the
Esc ( > ) button is pressed and released.
The figure below show the result of pressing the Esc ( > ) button a total of three
times.
ESC ESC ESC
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
26
10
27
11
I
N
3.5 4.0 4.5 5.0 3.0 2.5 2.0 1.5 1.0 0.5
Press the Esc button to increase the RGB interval that is applied to switches to
the selected output by a half second per button push.
The Input 1 through Input 10 buttons display the selected output's RGB delay.
Each lit input button indicates 0.5-second of delay.
In this example, the lit input buttons display 5.0 seconds of RGB interval.
N You can press and hold the Esc ( > ) or View ( < ) button to ramp the delay up or
down to the high or low limit.