Physio-Control LIFEPAK 15 - Manual (Page 182)

8-4
LIFEPAK 15 Monitor/Defibrillator Operating Instructions
Preparing the Monitor for Transmission
Preparing the Monitor for Transmission
Before you can transmit using a wireless or direct connection, you must define transmission sites
and output ports in the LIFEPAK 15 monitor Setup mode.
For each transmission site, select an output port:
• For wireless transmission, set OUTPUT PORT to BLUETOOTH WIRELESS .
• For a direct connection, set OUTPUT PORT to DIRECT CONNECT .
• Set OUTPUT PORT to BOTH if you normally transmit using a Bluetooth connection but you need a
direct cable backup. (If you set OUTPUT PORT to BOTH , make sure the Bluetooth LED is not
illuminated before you attempt to transmit using a direct connection. The device will not
transmit using the direct connection when a wireless connection is available.)
For more information, see the LIFEPAK 15 Monitor/Defibrillator Setup Options provided with your
device.