Clear-Com FreeSpeak Antenna Splitter - Manual (Page 106)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
6 - 6
Caution: Do not put battery packs containing
alkaline batteries into a recharger, or recharge
them in the beltpack. Serious damage or injury
could result.
Belt Clip
The belt clip is spring-loaded with enough tension to hold the beltpack
to the user’s belt and against the hip. Note that the upper portion of the
rear of the beltpack connected to the belt clip is a separate piece; the
entire belt clip assembly may be replaced in case of damage.
BELTPACK BOTTOM CONNECTOR SECTION
Figure 6-5: View of Bottom of Beltpack
Data Connector
This 3.5 mm (1/8 inch) tip-ring-sleeve (TRS) connector is used to
connect the beltpack to a computer in order to identify the beltpack to
the basestation during initial registration and system setup. It may also
be used if an upgrade to the beltpack firmware is ever required in the
future, to add new features and capabilities. See the section
“Registering the Beltpack with the Basestation” for further details.
Headset Connector
The male 4-pin headset connector provides audio pathways for the
headset microphone and headset earpiece(s). This connector
supports all Clear-Com and compatible headsets using female 4-pin
connectors. It will support dynamic microphones.
3
1
2