Clear-Com FreeSpeak Antenna Splitter - Manual (Page 46)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
3 - 2
UNDERSTANDING FRONT-PANEL OPERA-
TION
Figure 3-1: FreeSpeak Basestation Front Panel
Headset Connector
The 4-pin male XLR-type headset socket connects to Clear-Com
headsets and other headsets with 4-pin female connectors. This
headset connector is for the onboard two-channel intercom, with
controls just to the right of the connector.
& Channel A Talk Switch and Light/Listen
Level Knob
The channel A talk switch and associated light, and listen level knob,
allow full-duplex conversations with any FreeSpeak wireless beltpacks
or other communications systems wired to the rear of the basestation
to which the onboard Channel A has been assigned. Assignments are
done via the front-panel programming.
The talk switch is momentary/latching, such that pressing it and
holding down will create a talk path that ends when the user releases
the switch, while quickly tapping it will latch the talk, and a second tap
will release it. The LED lights red when a talk is active.
Turning the listen level knob clockwise will allow the user to hear the
other party’s voice, increasing the level to maximum when fully
clockwise.
The audio level is shown on the beltpack screen next to the battery
display.
1
2 3