Clear-Com FreeSpeak Antenna Splitter - Manual (Page 111)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual 6 - 1 1
• First letter in uppercase, rest lowercase - DTL
• All lowercase - Listen
To activate a talk or listen to an assigned source or destination (“label”)
1. Use the beltpack’s scroll buttons to scroll to the page on which the
desired assignment (“label”) appears. The beltpack holds three
pages of assignments. Each page displays two assignments.
As the display is scrolled “beeps” will be heard in the headset that
correspond to the page displaying on the beltpack: 1 beep for page
1, 2 beeps for page 2, etc.
2. When the appropriate page is reached select one or both of the
assignments on that page by depressing the corresponding talk
buttons on the beltpack (A or B).
3. Press and hold the appropriate talk button to talk or listen to the
destination. Release the button to close the talk or listen path.
Alternatively quickly tap the talk button to latch it “on”. Quickly tap it
again to release the latch.
4. To activate another communication route, repeat steps 1 through 3.
It is possible to keep all six communication routes “open” at the same
time. All activity on these routes will be heard in the headset.
Note: Two-wire and four-wire devices can have dual
talk-and-listen or just listen assignments.
SETTING AND ADJUSTING LISTEN LEVELS
A beltpack’s incoming audio volume (“listen level”) can be adjusted in
two ways:
• The overall maximum level for the beltpack can be set by using
the beltpack menu options.
• The incoming audio level can be adjusted during talk or listen on
the beltpack using the beltpack’s talk buttons.
To adjust the overall maximum “listen level” for a beltpack
1. From the beltpack’s display, scroll to Audio Options, then Headset
Options, then Master Level.
2. Select Master Level by pressing the enter button.
A bar graph appears on the display.
3. Using the right and left scroll keys, adjust the level up or down as
desired on the bar graph.
Typically, the level control will be set to around 2/3 of maximum.
4. When the desired level is reached, press the enter button.
That selection is saved in the beltpack’s memory. The display
returns to the previous screen.
To adjust the listen level during talk or listen from the beltpack