Clear-Com FreeSpeak Antenna Splitter - Manual (Page 81)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual 5 - 1 1
the selection process. Continue selecting the BACK command until
the desired screen is reached.
7. The changes are saved and applied automatically five seconds after
the last time the setup/enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
To edit a group that already has members, go through the procedure
above to reach the member labels. Scroll through the list, using
presses of the rotary encoder to select and de-select members. Exit as
above, and save the changes in the system memory.
BELTPACKS
The following steps have been completed in setting up the system:
• Created names (“labels”) for the FreeSpeak beltpacks and for the
devices wired to the base-station’s rear panel
• Created names (“labels”) for communication groups and assigned
members to the each group.
The next step is to assign these communication routes to the individual
FreeSpeak beltpacks.
For this example, communication routes are assigned to the beltpack
in position one—BPK01. The procedure is identical for all remaining
beltpacks.
1. Selecting the ‘BELTPACKS’ entry on the main menu displays the
menus for configuring beltpacks on the basestation.
Figure 5-20: First Beltpack Menu
2. Use the Setup/Enter knob to scroll to the second beltpack menu.
Figure 5-21: Second Beltpack Menu
ASSIGNING LABELS TO BELTPACKS KEYS
To assign talk and listen routes (“labels”) to a beltpack’s keys
1. From the MAIN menu, select BELTPACKS.
The AVAILABLE BELTPACKS screen is displayed.
SELECTED BPK01 - BPK01
GROUPS LATCH BACK KEYS
SELECTED BPK01 - BPK01
REGISTER LEVELS BACK LABELS