Stage announce relay, Wire matrix ports, Base loop connector (not used) – Clear-Com FreeSpeak Antenna Splitter User Manual

Page 51: Lan connector, Pc connector, Transceiver connectors, Stage announce relay -3, Wire matrix ports -3, Base loop connector (not used) -3, Lan connector -3

Advertising
background image

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual

4 - 3

Stage Announce Relay

This DB-9 male connector provides a relay closure that is triggered
simultaneously with the SA Output. The relay may be used to open an
audio pathway for the signal from the SA Output, or could also be used
to activate a light or lock or some other device. The relay may be wired
for normally closed or normally open operation, and the signal appears
on pins 1 & 6 or 2 & 6. It is rated to a maximum of 30-VDC at 1 amp.

4-Wire Matrix Ports

These four RJ-45 connectors can connect four full-duplex (input pair
and output pair) audio connections from a 4-wire communications
device, digital matrix intercom, or similar – making them available to
the wireless beltpacks. Any of the 4-wire ports or the program input
can be assigned as IFB sources from the front panel.

Each of these connectors has its own time slot, and can be addressed
separately from a beltpack, or combined with other beltpacks and
rear-panel connectors in a group. Level adjustment is done via the
front-panel display programming.

Base Loop Connector (not used)

The connector has no function in Freespeak V2.0.

LAN Connector

This RJ-45 connector allows the basestation to be connected to a LAN
for system software upgrades and configuration downloads from the
Configuration Editor. It is a 10BaseT Ethernet port.

PC Connector

This female DB-9 connects to a PC computer for firmware updates and
monitoring of the system configuration. It functions as a serial port.

Transceiver Connectors

These two RJ-45 connectors connect the basestation to two remote
FS-TA transceiver/antennas or antenna splitters.

Each wired transceiver/antenna communicates with five wireless
beltpacks. Each antenna splitter provides connection for five
transceiver antennas. providing communication with up to a maximum
of 10 beltpacks depending upon available bandwidth.

Note: To meet FCC emissions requirements a ferrite must be

fitted on any CAT-5 cable plugged into either of the two

6

7

8

9

10

11

Advertising
This manual is related to the following products: