Clear-Com FreeSpeak Antenna Splitter - Manual (Page 113)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual 6 - 1 3
The second function is to call another beltpack even though it
does not have the same “label” assigned to it that is assigned on
the local beltpack. The destination beltpack’s “label” must be
assigned to the local beltpack however to make this type of call.
For example, a stage manager labeled “STMGR” has a lighting crew
member’s label “LGT1” assigned to the “STMGR” beltpack. However,
the lighting crew member does not have the stage manager’s label
assigned to the “LGT1” beltpack.
The stage manager can call the lighting crew member in the usual way.
The lighting crew member can answer the call with the “answer-back”
button and establish a private conversation. The lighting crew member
cannot however initiate a direct call back to the stage manager.
BELTPACK MENU OPTIONS
The FreeSpeak beltpack presents the user with a number of adjustable
parameters. The main categories of the adjustments are: Alarm
Options, Audio Options, View Status, and Adjust Contrast accessed
through the menu. To enter menu mode hold down both page buttons
simultaneously until the beltpack enters menu mode (about 5
seconds).
An icon of an upward pointing arrow designates EXIT or BACK, and is
available on each menu page. Selecting this icon and pressing the
center ENTER button takes the user to the previous screen or exits to
the beltpack’s main menu.
ALARM OPTIONS
Low Battery Alarm
The low-battery alarm has three settings: ON1, ON2 and OFF. Using
the scroll keys, select the desired setting and then press the center
ENTER key.
• When ON is selected the user will hear a beep at intervals in the
headset to indicate that it is time to replace or recharge the
belpack batteries. This will occur when the battery level is
sufficiently low. The battery indicator will also flash.
• When ON2 is selected the threshold setting is used to trigger the
alarm.
• When OFF is selected the user will not be warned of low battery
level.
Low Signal Alarm
The low-signal alarm has two settings: on and off. Using the scroll
keys, select the desired setting and then press the center ENTER key.