Clear-Com FreeSpeak Antenna Splitter - Manual (Page 89)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual 5 - 1 9
11. The changes are saved and applied automatically five seconds
after the last time the setup/enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
In some cases, the audio paths must be re-made before the changes
will take effect.
SETTING PORT CALL DESTINATION
Party Line, 4-Wire, Stage Announce and Program ports can also have
call destinations configured. In this case any audio on the port will
immediately be routed to the specified destination which may be any of
the other available ports. If the VOX trigger is set then audio on this
port will be routed to the destination when the specified threshold is
exceeded.
1. From the MAIN menu, select ‘PORTS’. A menu of the available
audio ports is displayed.
Figure 5-40: Available Audio Ports Menu
2. Select the port for which the call destination is to be set (excludes
headset ports). The menu for the selected port will be displayed.
Figure 5-41: Selected Port Menu for Calls
3. Select ‘CALLS’ from the menu. The call destination menu will be
displayed.
Figure 5-42: Port Call Menu
4. Use the Setup/Enter knob to scroll through the available ports and
select the required destination port. It is possible to select the
source port as the call destination to create an audio loopback
system. This may be used for audio testing purposes.
AVAILABLE AUDIO PORTS
PLCHA
PLCHA PLCHB
PLCHB STGAN
STGAN PRGRM
PRGRM
BACK
4WIR4
4WIR4
SELECTED 4WIR4 - 4WIR4
BACK
GROUPS
LEVELS LABEL CALLS
CALL DESTINATION FOR 4WIR4 IS NONE
BACK
NONE
NONE