Clear-Com FreeSpeak Antenna Splitter - Manual (Page 148)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
9 - 6
Table 9-1: How antennas are numbered
GETTING INFORMATION ON ACTIVE ANTENNA STA-
TUS
The user can also monitor which beltpacks are connected to which
antennas using the basestation’s SYSTEM menu.
When the user selects ANTNS from the SYSTEM menu, the display
shows the status of the active antennas that are connected to the
basestation, and shows the slots on each antenna that are occupied by
beltpacks. This information may be useful during a site survey, or when
troubleshooting coverage areas or antenna connections.
A typical display is shown below:
Figure 9-3: ANTNS menu
The numbers 1 through 10 represent the maximum number of
antennas that can be connected to the basestation. Numbers 1
through 5 can be positions on a splitter connected to transceiver port 1,
while 6 through 10 can be positions on a splitter connected to
transceiver port 2. An antenna connected directly to transceiver port 2
would appear at position 6.
“__” indicates an empty slot on an acive antenna that is connected to
the basestation. A number in place of a “__” indicates that this slot is
occupied by the indicated beltpack.
BELTPACK SCREEN DISPLAYS: WHICH SIGNIFIES:
RPN 6 Antenna 1 on transceiver port 1
RPN 7 Antenna 2 on transceiver port 1
RPN 8 Antenna 3 on transceiver port 1
RPN 9 Antenna 4 on transceiver port 1
RPN 10 Antenna 5 on transceiver port 1
RPN 11 Antenna 1 on transceiver port 2
RPN 12 Antenna 2 on transceiver port 2
RPN 13 Antenna 3 on transceiver port 2
RPN 14 Antenna 4 on transceiver port 2
RPN 15 Antenna 5 on transceiver port 2
1> ---- ---- ---- ---- ----
2> ---- ---- ---- ---- ----
3> 2 4 ---- ---- ----
4>
5> SYSTEM: 1
TOTAL ONLINE: 4 6> 1 ---- ---- ---- ----
7> 3 ---- ---- ---- ----
8>
9>
10>