Clear-Com FreeSpeak Antenna Splitter - Manual (Page 112)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
6 - 1 2
• During talk and listen, rotate an assignment’s talk button to
increase or decrease the incoming volume level (“listen level”) for
that assignment.
• When scrolling between pages, the listen levels for the various
assignments remain intact. For example, rotating the talk button
to increase or decrease the listen level for the first assignment on
page 2 will not affect the listen level set with the same talk button
on page 1 or 3.
• The three lights next to each talk button, labeled “Vol A” and Vol
B,” show the current listen level. At the lowest audio level, the
green light illuminates. As the listen level increases to moderate,
the yellow light illuminates, and as it increases to maximum, the
red light illuminates. Note that the position of the talk button does
not affect the level that is heard or indicated by the lights.
Note: For beltpacks that have both a Direct Key to a panel and a
Group Key containing the same panel as the Direct Key the
Direct Key will affect the listen volume level in that Group.
If the listen volume of the Direct Key to the panel is turned
down to -70db/silent and then removed from the beltpack
then listening to the group key containing that panel will
now result in the panel volume being set to -70db/silent.
HEADSET LIMITER
The overall headset volume may also be affected by the headset
limiter value set on the beltpack. See section “BELTPACK MENU
OPTIONS” for more details.
USING THE BELTPACK ANSWER-BACK FUNCTIONS
A beltpack’s “answer-back” key performs two functions:
The first function is to answer a call from a source whose “label”
does not appear on the currently selected beltpack page.
When audio is received from a source whose label does not appear on
the currently selected beltpack page, but whose label does appear on
a non-selected page, the beltpack’s “answer-back” light will flash. The
user will also hear the caller’s voice in the headset at whatever
incoming volume was previously set for that label.
This call can be answered in one of two ways:
• Press the front-panel “answer-back” button on the beltpack. This
establishes a return talk path to the calling beltpack. Press and
hold the button to talk or quickly tap the button to “latch” it on.
• Use the front-panel scroll buttons to scroll to the page where the
source’s label appears and press the appropriate talk button as
usual.