Clear-Com FreeSpeak Antenna Splitter - Manual (Page 97)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual 5 - 2 7
SYSTEM INFO (“INFO”)
When INFO is selected the screen displays the system’s current
firmware version, DECT system ID (for registering beltpacks), and if
applicable, IP address.
Figure 5-62: System Info Menu
To return to the SYSTEM menu, press the setup/enter button.
RESTORING THE DEFAULTS (“DEFAULT”)
When DEFAULT is selected a screen appears asking the user to
confirm restoring the last configuration downloaded with reset applied.
The default is ‘NO’. Select either yes or no.
Figure 5-63: Restore Defaults Menu
ANTENNAS (“ANTENNAS”)
When ANTENNAS is selected the display shows the status of the
active antennas that are connected to the basestation, and shows the
slots on each antenna that are occupied by beltpacks. This information
may be useful during a site survey, or when troubleshooting coverage
areas or antenna connections.
A typical display is shown below:
Figure 5-64: ANTENNAS menu
The numbers 1 through 10 represent the maximum number of
antennas that can be connected to the basestation. Numbers 1
through 5 can be positions on a splitter connected to transceiver port 1,
while 6 through 10 can be positions on a splitter connected to
transceiver port 2. An antenna connected directly to transceiver port 2
would appear at position 6.
BUILD: JAN 21 2009 17:29:37 V2.0.0.037 => NEW FROM A
SYSTEMID: 100EC012 (A11)SYS:1 IPADDRESS: 129.67.61.36
CARRIERS: 0000 000300 RAM: 16MB FPGA:2.1
COPYRIGHT 2004-2008 VITEC GROUP COMMUNICATIONS
Select map...
F.DEFAULT USER MAP BACK
1> ---- ---- ---- ---- ----
2> ---- ---- ---- ---- ----
3> 2 4 ---- ---- ----
4>
5> SYSTEM: 1
TOTAL ONLINE: 4 6> 1 ---- ---- ---- ----
7> 3 ---- ---- ---- ----
8>
9>
10>