Clear-Com FreeSpeak Antenna Splitter - Manual (Page 154)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
1 0 - 4
RETRIEVING A CONFIGURATION FROM A FREES-
PEAK BASESTATION VIA ETHERNET
• Connect the PC and the basestation to the local network and set
up an IP address on the basestation.
• Click the ‘Retrieve’ button in the "LAN" section of the dialog. A
progress window will be displayed showing the upload.
Figure 10-5: Map Upload Progress
• Retrieval of the configuration should take around 15 secs. If the
program fails to connect to the Freespeak basestation, the
following dialog will be displayed:
Figure 10-6: Configuration Editor Ethernet Timeout
• If this occurs, check the ethernet connections at the PC and the
basestation. Ensure that the IP address is correct and that it is
valid for use on the local network.
• Once the configuration has been retrieved from the basestation,
the display should appear as follows: