Clear-Com FreeSpeak Antenna Splitter - Manual (Page 86)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
5 - 1 6
SETTING BELTPACK LABELS
1. From the MAIN menu, select BELTPACKS.
The AVAILABLE BELTPACKS screen is displayed (see Figure 5-5).
2. Select the beltpack for which audio levels are to be set. The
BELTPACK menu is displayed. Scroll to the second beltpack menu
using the Setup/Enter knob.
Figure 5-32: Labels Selected on the Beltpack Menu
3. Select ‘LABELS’. The beltpack label editing menu is displayed, as
shown in Figure 5-33.
Figure 5-33: Beltpack Label Editing Menu
4. Scroll to and select the alphanumeric character to be changed. A
box appears around the character.
5. Rotate the setup/enter knob. As the knob is rotated the entire range
of available characters appears, starting with upper-case
characters, proceeding to lower-case characters, then to digits, and
finally to punctuation characters.
6. When the desired new character appears, press the setup/enter
knob to select it. The box disappears, and is replaced by the solid
highlight.
7. Repeat steps 4 through 6 for all the characters in the label that are
to be changed.
8. When editing the label is completed select ‘BACK’ to return to the
previous menu.
9. The changes are saved and applied automatically five seconds after
the last time the Setup/Enter knob was pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
REGISTERING A BELTPACK
Beltpacks can be registered directly with a basestation from the front
panel as well as using the Configuration Editor by entering the beltpack
serial number.
1. From the MAIN menu, select BELTPACKS.
The AVAILABLE BELTPACKS screen is displayed (see Figure 5-5).
SELECTED BPK01 - BPK01
REGISTER LEVELS BACK LABELS
Enter name for - BPK01
B P K 0 1 BACK