Clear-Com FreeSpeak Antenna Splitter - Manual (Page 42)

Clear-Com Communication Systems
FreeSpeak V2.0 Instruction Manual
2 - 1 0
• Examine the wired beltpack attached to party-line channel A.
It should be possible to hear audio from beltpack #1 in the wired
beltpack’s headset. If the microphone of the wired beltpack is
opened the wireless beltpack should also be able to hear the
audio.
• The 4-wire device should have 2-way audio. The wireless
beltpack should be able to hear audio from the 4-wire device, and
the 4-wire device should be able to hear audio from the wireless
beltpack.
• Examine wireless beltpack #2. If it is on page #1, the green
(listen) light should be flashing and it should be possible to hear
audio from beltpack #1. At this point, beltpack #1 won’t be able to
hear audio from beltpack #2.
3. Press the leftmost rotary knob on beltpack #2, which is next to the
flashing green light.
All stations are able to hear beltpack #2 as well as beltpack #1. In
other words, all stations can hear each other.
4. Press the leftmost rotary controllers on beltpacks #1 and #2 briefly
to unlatch them. This deactivates all talk and listen paths.
CALLING THE WIRELESS PARTY LINE
FROM THE 4-WIRE AUDIO DEVICE
1. From the basestation’s front-panel menu, select PORTS, then
4WIR1, then CALLS, then WP#01.
The changes are saved and applied automatically five seconds after
the last time the setup/enter knob is pressed or turned. The
front-panel display flashes to indicate that the changes are being
saved and applied.
• All stations should now be able to hear the audio coming in from
the 4-wire device.
• On the two wireless beltpacks, the green (listen) lights should be
flashing, indicating an incoming call to wireless party line #1 from
a member of wireless party line #1.
2. Note that if the basestation is power cycled off and on again, the talk
paths from the 4-wire device are automatically re-established to the
wired beltpack and to the two wireless beltpacks.
3. It is possible to remove the talk paths from the 4-wire device to the
wired beltpack and to the two wireless beltpacks by selecting
PORTS, then 4WIR1, then CALLS, then NONE, from the
basestation’s front-panel menu.
4. Note that if the calling 4-wire port is included in the wireless party
line that is being called from the 4-wire device the 4-wire audio will
not be looped back to itself.