Brocade BigIron RX Series Configuration Guide - Manual (Page 1147)

BigIron RX Series Configuration Guide 1069
53-1002484-04
Displaying 802.1x information
34
In this example, the 802.1x-enabled port has been moved from VLAN 1 to VLAN 4094. When the
client disconnects, the port will be moved back to VLAN 1.
Displaying information on MAC address filters and IP ACLs on an
interface
You can display information about the user-defined and dynamically applied MAC address filters
and IP ACLs currently active on an interface.
Displaying MAC address filters applied to an 802.1x-enabled port
Use the show dot1x mac-address command to display information about MAC filters applied to an
interface. If the MAC address filter is dynamically assigned by 802.1x, the display shows the
following.
BigIron RX#show dot1x mac-address ethernet 1/1
Port 1/1 MAC Address Filter information:
802.1x dynamic MAC Filter (user defined) :
mac access-list 401 in
Port default MAC Filter :
mac access-list 400 in
The "Port default MAC Filter" appears if a default MAC filter has been configured on the port. This
default MAC filter is the MAC filter that will be applied to the port once the dynamically assigned
MAC filter is removed. If a default MAC filter has not been configured, the message "No Port default
MAC is displayed.
When the dynamically assigned MAC address filter is removed, the display shows the following
information.
BigIron RX# show interface e 12/2
GigabitEthernet1/3 is up, line protocol is up
Hardware is GigabitEthernet, address is 000c.dbe2.5800 (bia 000c.dbe2.5800)
Configured speed auto, actual 100Mbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual MDIX
Member of L2 VLAN ID 4094 (dot1x-RADIUS assigned), original L2 VLAN ID is 1,
port is untagged, port state is Forwarding
STP configured to ON, Priority is level0, flow control enabled
Force-DSCP disabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
Internet address is 12.12.12.250/24, MTU 1522 bytes, encapsulation ethernet
300 second input rate: 810 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 1253 bits/sec, 1 packets/sec, 0.00% utilization
70178 packets input, 7148796 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 70178 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants, DMA received 70178 packets
91892 packets output, 10081165 bytes, 0 underruns
Transmitted 9853 broadcasts, 13330 multicasts, 68709 unicasts
0 output errors, 0 collisions, DMA transmitted 91892 packets
Port Translation counter 8, Port UP counter 4,Port Down Counter 4
Last port state change at:May 15 11:42:59
Port Translation counter for last 5min =5, 1hr =8, 24hr =8 and 30days =8