Brocade BigIron RX Series Configuration Guide - Manual (Page 1416)

1338 BigIron RX Series Configuration Guide
53-1002484-04
Displaying OSPFv3 information
49
Displaying IPv6 OSPF virtual link information
To display OSPFv3 virtual link information for the Brocade device, enter the following command at
any level of the CLI.
Syntax: show ipv6 ospf virtual-link
This display shows the following information.
Displaying OSPFv3 virtual neighbor information
To display OSPFv3 virtual neighbor information for the Brocade device, enter the following
command at any level of the CLI.
Syntax: show ipv6 ospf virtual-neighbor
This display shows the following information.
TABLE 237 OSPFv3 virtual link information
This field... Displays...
Index An index number associated with the virtual link.
Transit Area ID The ID of the shared area of two ABRs that serves as a connection point between the
two routers.
Router ID IPv4 address of the router at the other end of the virtual link (virtual neighbor).
Interface Address The local address used to communicate with the virtual neighbor.
State The state of the virtual link. Possible states include the following:
•
P2P – The link is functioning as a point-to-point interface.
•
DOWN – The link is down.
TABLE 238 OSPFv3 virtual neighbor information
This field... Displays...
Index An index number associated with the virtual neighbor.
Router ID IPv4 address of the virtual neighbor.
Address The IPv6 address to be used for communication with the virtual neighbor.
BigIron RX# show ipv6 ospf virtual-link
Index Transit Area ID Router ID Interface Address State
1 1 1.1.1.1 3003::2 P2P
BigIron RX# show ipv6 ospf virtual-neighbor
Index Router ID Address State Interface
1 1.1.1.1 3002::1 Full ethe 2/3