Brocade BigIron RX Series Configuration Guide - Manual (Page 182)

104 BigIron RX Series Configuration Guide
53-1002484-04
Configuring authentication-method lists
3
The show web command displays the privilege level of Web management interface users.
Syntax: show web
Configuring authentication-method lists
To implement one or more authentication methods for securing access to the device, you configure
authentication-method lists that set the order in which the authentication methods are consulted.
In an authentication-method list, you specify the access method (Telnet, Web, SNMP, and so on)
and the order in which the device tries one or more of the following authentication methods:
• Local Telnet login password
• Local password for the Super User privilege level
• Local user accounts configured on the device
• Database on a TACACS or TACACS+ server
• Database on a RADIUS server
• No authentication
NOTE
The TACACS and TACACS+, RADIUS, and Telnet login password authentication methods are not
supported for SNMP access.
TABLE 39 Output of the show aaa command for RADIUS
Field Description
Radius key The setting configured with the radius-server key command. At the Super User privilege
level, the actual text of the key is displayed. At the other privilege levels, a string of periods
(....) is displayed instead of the text.
Radius retries The setting configured with the radius-server retransmit command.
Radius timeout The setting configured with the radius-server timeout command.
Radius dead-time The setting configured with the radius-server dead-time command.
Radius Server For each RADIUS server, the IP address, and the following statistics are displayed:
Auth PortRADIUS authentication port number (default 1645)
Acct PortRADIUS accounting port number (default 1646)
opensNumber of times the port was opened for communication with the server
closesNumber of times the port was closed normally
timeoutsNumber of times port was closed due to a timeout
errorsNumber of times an error occurred while opening the port
packets inNumber of packets received from the server
packets outNumber of packets sent to the server
connection The current connection status. This can be “no connection” or “connection active”.
BigIron RX(config)# show web
User Privilege IP address
set 0 192.168.1.234