Brocade BigIron RX Series Configuration Guide - Manual (Page 307)

BigIron RX Series Configuration Guide 229
53-1002484-04
Displaying IP information
7
The show ip cache and show ip network commands entered on the rconsole display the following
information.
Displaying the IP route table
To display the IP route table, enter the following command at any CLI level.
TABLE 58 CLI display of IP forwarding cache
This field... Displays...
IP Address The IP address of the destination.
Next Hop The IP address of the next-hop router to the destination. This field contains
either an IP address or the value DIRECT. DIRECT means the destination is
either directly attached or the destination is an address on this Brocade
device. For example, the next hop for loopback addresses and broadcast
addresses is shown as DIRECT.
MAC The MAC address of the destination.
NOTE: If the entry is type U (indicating that the destination is this Brocade
device), the address consists of zeroes.
Type The type of host entry, which can be one or more of the following:
•
D – Dynamic
•
P – Permanent
•
F – Forward
•
U – Us
•
C – Complex Filter
•
W – Wait ARP
•
I – ICMP Deny
•
K – Drop
•
R – Fragment
•
S – Snap Encap
Port The port through which this device reaches the destination. For
destinations that are located on this device, the port number is shown as
“n/a”.
VLAN Indicates the VLANs the listed port is in.
Pri The QoS priority of the port or VLAN.
BigIron RX>rconsole 15
Connecting to slave CPU 15/1... (Press CTRL-Shift-6 X to exit)
rconsole-15/1@LP>show ip network
Total number of host cache entries 3
D: Dynamic P:Permanent, F:Forward U:Us C:Conected Network
W:Wait ARP I:ICMP Deny K:Drop R:Frament S:Snap Encap N:CAMInvalid
IP Address Next Hop MAC Type Port VLAN Pri
1 0.0.0.0/0 DIRECT 0000.0000.0000 PK n/a 0
2 20.1.1.0/24 DIRECT 0000.0000.0000 PC n/a 0
3 40.40.40.0/24 30.1.1.10 0000.0000.0033 PF 15/14 154 1