Displaying vsrp packet statistics for vsrp – Brocade BigIron RX Series Configuration Guide User Manual

Page 527

Advertising
background image

BigIron RX Series Configuration Guide

449

53-1002484-04

Displaying VSRP information

15

BigIron RX# show vsrp brief

VLAN VRID ConfPri CurPri P State PeerMacAddr or IpAddress VIP

10 10 100 80 P Master Unknown Unknown None

When the command is entered on a Layer 3 VSRP, it displays the following information.

BigIron RX# show vsrp brief

VLAN VRID ConfPri CurPri P State PeerMacAddr or IpAddress VIP

100 1 150 1 P Initia xxxx.1414.1404 20.20.20.4 20.20.20.100

101 2 50 1 P Initia xxxx.1e1e.1e01 30.30.30.1 30.30.30.100

Syntax: show vsrp brief

Displaying VSRP packet statistics for VSRP

When Layer 3 VSRP is enabled, you can enter the following command to display VSRP statistics.

BigIron RX# show vsrp statistics

Global VSRP statistics

----------------------

- received packets with checksum errors = 0

- received packets with invalid version number = 0

- received packets with unknown or inactive vrid = 43

To display VSRP statistics for a specific VLAN, enter a command such as the

following:

BigIron RX# show vsrp statistics vlan 100

This field...

Displays...

VLAN

The VLAN on which VSRP is configured.

VRID

The VRID for which the following information is displayed.

ConfPri

The configured priority for the device’s preferability for becoming the Master
for the VRID.

CurPri

The device’s current priority for becoming the Master.

P

Pre-empt mode status:

P – pre-emption is enabled for the VLAN

N – pre-emption is disabled for the VLAN

state

This device’s VSRP state for the VRID. The state can be one of the following:

initialize – VSRP is not enabled on the VRID. If the state remains
“initialize” after you enable VSRP on the VRID, make sure that the VRID
is also configured on the other routers and that the routers can
communicate with each other.

NOTE: If the state is “initialize” and the mode is incomplete, make sure you

have specified the IP address for the VRID.

standby – This device is a Backup for the VRID.

master – This device is the Master for the VRID.

Peer MAC address or IP address

MAC address or IP address of the peer.

VIP

Virtual IP address for the VLAN.

Advertising