Brocade BigIron RX Series Configuration Guide - Manual (Page 65)

BigIron RX Series Configuration Guide lxv
53-1002484-04
Enhancements in release 02.3.00
System enhancements
TABLE 16 System enhancements
Enhancement Description See...
New Hardware
Support The following new hardware is supported with the 02.3.00
software release for the BigIron RX:
1
10G-XFP-CX4 - part number 10G-XFP-CX4 , A new XFP
Module is available for use in the BigIron RX Series and
10G Interface Modules with the following capabilities:
•
10GBASE-CX4 compliant per 802.1ak
•
CX4 connector
•
Up to 15 meter reach when using CX4 grade copper
cables
•
Restriction of Hazardous Substances (RoHS) 5/6
compliant
•
Hot pluggable
•
Compatible with industry-standard MDI socket for
CX4
•
Supports 4 channel full-duplex copper cable
2 10GBase-ZR – part number 10G-XFP-ZR supports 1550
nm wavelength with a maximum distance of up to 80 km
over single mode fiber (SMF).
3 10GBase-ZRD – part number 10G-XFP-ZRD supports 40
different wavelengths at 1550 nm.
4 48-port 1 Gbps Copper Ethernet interface module
Book: Brocade BigIron RX
Series Hardware
Installation Guide
Hitless OS Upgrade
for Layer 2 Version 02.5.00 of the Multi-Service IronWare software
supports hitless upgrade of the operating system on a BigIron
RX switch. Using this feature, you can upgrade the
Multi-Service IronWare software without a loss or disruption of
service as described. Book: Brocade BigIron RX
Series Hardware
Installation Guide
Chapter: Upgrading
Software Images and
Configuration Files
Section:Layer 2 Hitless OS
Upgrade
Logging of packets
denied by ACLs. You can restrict the number of times a message is logged in
the Syslog due to packets that matches a deny ACL condition. Book: BigIron RX Series
Configuration Guide
Chapter:
“Access Control
List”
Section: “Enabling the
new logging method”
Modifying ACLs You can modify ACL entries anywhere in an ACL. Book: BigIron RX Series
Configuration Guide
Chapter:
“Access Control
List”
Section: “Enabling the
new logging method”
SFM FE Monitoring In this release, the Switch Fabric Module monitoring has been
enhanced. If the SFM fails, it generates a syslog that includes
the status of individual fabric elements on the SFM modules. Book: Brocade BigIron RX
Series Hardware
Installation Guide