Brocade BigIron RX Series Configuration Guide - Manual (Page 358)

280 BigIron RX Series Configuration Guide
53-1002484-04
Resetting LLDP statistics
9
Resetting LLDP statistics
To reset LLDP statistics, enter the clear lldp statistics command at the Global CONFIG level of the
CLI. The Brocade device will clear the global and per-port LLDP neighbor statistics on the device
(refer to
“LLDP statistics” on page 275).
BigIron RX# clear lldp statistics
Syntax: clear lldp statistics [ports ethernet <slot num/port num> | all]
If you do not specify any ports or use the keyword all, by default, the system will clear lldp statistics
on all ports.
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually.