Clearing ipv6 mld traffic – Brocade BigIron RX Series Configuration Guide User Manual
Page 1443
BigIron RX Series Configuration Guide
1365
53-1002484-04
Multicast Listener Discovery and source specific multicast protocols (MLDv2)
50
The report has a Receive and a Send section. These sections show the following information.
Syntax: show ipv6 mld traffic
Clearing IPv6 MLD traffic
To clear statistics on IPv6 MLD traffic, enter the following command.
BigIron RX(config)#clear ipv6 mld traffic ethernet 7/10
Syntax: clear ipv6 mld traffic ethernet <slot-number>/<port-number> | ve <ve-number>
Select ethernet and enter the interface’s slot number and port number to clear MLD traffic on a
physical interface.
This field
Displays
QryV1
Number of general MLDv1 queries received or sent by the virtual routing interface.
QryV2
Number of general MLDv2 queries received or sent by the virtual routing interface.
G-Qry
Number of group specific queries received or sent by the virtual routing interface.
GSQry
Number of source specific queries received or sent by the virtual routing interface.
MbrV1
Number of MLDv1 membership reports received.
MbrV2
Number of MLDv2 membership reports received.
Leave
Number of MLDv1 “leave” messages on the interface. (See 2_Ex for MLDv2.)
Is_IN
Number of source addresses that were included in the traffic.
Is_EX
Number of source addresses that were excluded in the traffic.
2_IN
Number of times the interface mode changed from exclude to include.
2_EX
Number of times the interface mode changed from include to exclude.
ALLOW
Number of times that additional source addresses were allowed or denied on the interface.
BLK
Number of times that sources were removed from an interface.
BigIron RX #show ipv6 traffic
Recv QryV1 QryV2 G-Qry GSQry MbrV1 MbrV2 Leave IS_IN IS_EX 2_IN 2_EX ALLO BLK
e3/1 0 0 0 0 0 0 0 0 0 0 0 0 0
e3/2 0 0 0 0 0 0 0 0 0 0 0 0 0
e6/18 0 0 0 0 0 176 0 110 0 0 0 66 0
e6/19 0 0 0 0 0 176 0 110 0 0 0 66 0
e6/20 0 0 0 0 0 176 0 110 0 0 0 66 0
e6/25 0 0 0 0 0 176 0 110 0 0 0 66 0
l1 0 0 0 0 0 0 0 0 0 0 0 0 0
Send QryV1 QryV2 G-Qry GSQry
e3/1 0 0 0 0
e3/2 0 0 0 0
e6/18 0 10 10 0
e6/19 0 10 10 0
e6/20 0 10 10 0
e6/25 0 10 10 0
l1 0 0 0 0
R2#