Brocade BigIron RX Series Configuration Guide - Manual (Page 313)

BigIron RX Series Configuration Guide 235
53-1002484-04
Displaying IP information
7
Displaying TCP traffic statistics
You can use the show ip tcp traffic command to display TCP traffic statistics.
BigIron RX# show ip tcp traffic
TCP Statistics
233 active opens, 0 passive opens, 1659 failed attempts 117547
active resets, 0 passive resets, 116511 input errors 141627 in
segments, 18866 out segments, 71 retransmission
Syntax: show ip tcp traffic
input errors This information is used by Brocade customer support.
in segments The number of TCP segments received by the device.
out segments The number of TCP segments sent by the device.
retransmission The number of segments that this device retransmitted because the
retransmission timer for the segment had expired before the device at the
other end of the connection had acknowledged receipt of the segment.
RIP statistics
The RIP statistics are derived from RFC 1058, “Routing Information Protocol”.
requests sent The number of requests this device has sent to another RIP router for all or
part of its RIP routing table.
requests received The number of requests this device has received from another RIP router for
all or part of this device’s RIP routing table.
responses sent The number of responses this device has sent to another RIP router’s
request for all or part of this device’s RIP routing table.
responses received The number of responses this device has received to requests for all or part
of another RIP router’s routing table.
unrecognized This information is used by Brocade customer support.
bad version The number of RIP packets dropped by the device because the RIP version
was either invalid or is not supported by this device.
bad addr family The number of RIP packets dropped because the value in the Address Family
Identifier field of the packet’s header was invalid.
bad req format The number of RIP request packets this router dropped because the format
was bad.
bad metrics This information is used by Brocade customer support.
bad resp format The number of responses to RIP request packets this router dropped
because the format was bad.
resp not from rip port This information is used by Brocade customer support.
resp from loopback The number of RIP responses received from loopback interfaces.
packets rejected This information is used by Brocade customer support.
TABLE 60 CLI display of IP traffic statistics (Continued)
This field... Displays...