Brocade BigIron RX Series Configuration Guide - Manual (Page 767)

BigIron RX Series Configuration Guide 689
53-1002484-04
Displaying PIM Sparse configuration information and statistics
24
• Group information
• BSR information
• Candidate RP information
• RP-to-group mappings
• RP information for a PIM Sparse group
• RP set list
• PIM Neighbor information
• The PIM flow cache
• The PIM multicast cache
• PIM traffic statistics
Displaying basic PIM Sparse configuration information
To display PIM Sparse configuration information, enter the following command at any CLI level.
Syntax: show ip pim sparse
This example shows the PIM Sparse configuration information on PIM Sparse router A in
Figure 102 .
This display shows the following information.
This field... Displays...
Global PIM Sparse mode settings
Hello interval How frequently the BigIron RX sends PIM Sparse hello messages to its
PIM Sparse neighbors. This field show the number of seconds between
hello messages. PIM Sparse routers use hello messages to discover one
another.
Neighbor timeout How many seconds the BigIron RX will wait for a hello message from a
neighbor before determining that the neighbor is no longer present and
removing cached PIM Sparse forwarding entries for the neighbor.
BigIron RX(config-pim-router)# show ip pim sparse
Global PIM Sparse Mode Settings
Hello interval: 60, Neighbor timeout: 180
Bootstrap Msg interval: 130, Candidate-RP Advertisement interval: 60
Join/Prune interval: 60, SPT Threshold: 1
Interface Ethernet e3/8
TTL Threshold: 1, Enabled
Local Address: 207.95.8.1
Interface Ve 1
TTL Threshold: 1, Enabled
Local Address: 207.95.6.1