Brocade BigIron RX Series Configuration Guide - Manual (Page 1530)

1452 BigIron RX Series Configuration Guide
53-1002484-04
RIP
E
RIP
rate-limit in group < group-number> < average-rate>
< maximum-burst>
“Configuring a VLAN-group-based rate limiting policy”
on page 516
rate-limit in group < group-number> priority < num>
< average-rate> < maximum-burst>
“Configuring a VLAN-group-based rate limiting policy”
on page 516
rate-limit input priority < num> < average-rate>
< maximum-burst>
“Configuring a port-and-priority-based rate limiting
policy”
on page 515
rate-limit input < average-rate> < maximum-burst> “Configuring a port-based rate limiting policy” on
page 514
rate-limit input vlan < vlan-number> < average-rate>
< maximum-burst>
“Configuring a port-and-VLAN-based rate limiting
policy”
on page 515
rate-limit strict-acl “Configuring a port-and-IPv6 ACL-based traffic
reduction”
on page 518
rl-vlan-group < vlan-group-number> “Configuring a VLAN-group-based rate limiting policy”
on page 516
show rate-limit [counters [interface < slot/port>]] [group
[ < vlan-number>]] [interface < slot/port>]
“Displaying traffic reduction” on page 520
vlan < vlan-number> [to < vlan-number] “Configuring a VLAN-group-based rate limiting policy”
on page 516
Commands See ...
Commands See ...
clear ip rip local “Clearing the RIP routes from the routing table” on
page 751
clear ip rip routes < ip-addr> / < mask-bits> “Clearing the RIP routes from the routing table” on
page 751
default-metric < 1-15> “Changing the default redistribution metric” on
page 746
distance < num> “Changing the administrative distance” on page 745
ip prefix-list < name> permit | deny < source-ip-address> |
any < source-mask> | any
“Using prefix lists and route maps as route filters” on
page 749
ip rip learn-default “Configuring route learning and advertising
parameters”
on page 746
ip rip metric-offset < num> in | out “Changing the cost of routes learned or advertised on
a port”
on page 744
ip rip poison-reverse “Changing the route loop prevention method” on
page 747
ip rip prefix-list < name> in | out “Using prefix lists and route maps as route filters” on
page 749
ip rip route-map < name> in | out “Using prefix lists and route maps as route filters” on
page 749
ip rip v1-only | v1-compatible-v2 | v2-only “Enabling RIP” on page 744