Brocade BigIron RX Series Configuration Guide - Manual (Page 1150)

1072 BigIron RX Series Configuration Guide
53-1002484-04
Sample 802.1x configurations
34
Syntax: show dot1x mac-session brief [ | begin <expression> | exclude <expression> | include
<expression>]
The following table describes the information displayed by the show dot1x mac-session brief
command.
Sample 802.1x configurations
This section illustrates a sample point-to-point configuration and a sample hub configuration that
use 802.1x port security.
Point-to-point configuration
Figure 139 illustrates a sample 802.1x configuration with Clients connected to three ports on the
BigIron RX device. In a point-to-point configuration, only one 802.1x Client can be connected to
each port.
TABLE 176 Output from the show dot1x mac-session brief command
This field... Displays...
Port Information about the users connected to each port.
Number of users The number of restricted and authorized (those that were successfully
authenticated) users connected to the port.
Dynamic VLAN Whether or not the port is a member of a RADIUS-specified VLAN.
Dynamic ACL Whether or not a RADIUS-specified ACL has been applied to the port for
incoming (in) and outgoing (out) traffic.
Dynamic MAC Filters Whether or not a RADIUS-specified MAC Filter has been applied to the
port.