Brocade BigIron RX Series Configuration Guide - Manual (Page 1453)

BigIron RX Series Configuration Guide 1375
53-1002484-04
Continuous system monitor overview
52
MBridge FPGA
The event MBRIDGE FPGA is monitoring the MP MBridge FPGA status. If MBridge FPGA failure is
detected then send the sysmon error log and initiate the MP “switchover”. Here is an example from
Syslog.
if, MBridge Failure with valid address range (0xb000000 to 0xb1ffffff)
Feb 3 20:13:00:E:System: ALARM: MP MBridge FPGA read Failure (Read error Address:
0xb0000020)
if, MBridge Failure with invalid address range
Feb 3 20:13:00:E:System: ALARM: MP MBridge FPGA read Failure (Read error Address:
0xffffffff)
Display Commands
You can use the following show commands to view the results of the monitoring activity. These
show commands display information for all event types in one output.
Displaying internal log messages
Display the contents of the internal log by entering the following command.
BigIron RX# show sysmon logs
INFO:May 13 07:29:54: TM Link Error: LP2/TM2/Link2 -- SNM3/FE3/Link43 (disabled)
INFO:May 13 07:29:33: FE Link Error: SNM3/FE3/Link64 -- LP4/TM1/Link2 (disabled)
Syntax: show sysmon logs
NOTE
The size of the internal log table is 10000 logs.
Clearing internal logs
To clear the internal logs, enter the following command.
BigIron RX# clear sysmon logs
Syntax: clear sysmon logs
Displaying current SYSMON configuration
Enter the show sysmon configuration command to view the current configuration for system
monitoring services. Look for lines similar to the following:
BigIron RX# show sysmon config
--- Event TM Link (Enabled) ---
Threshold: 5 / 10, Log Backoff Number: 1800
Action: SHUTDOWN_LINK
----------------------------------
--- Event TM Clock Sync (Enabled) ---
Threshold: 1 / 10, Log Backoff Number: 1800
Action: SYSLOG
----------------------------------