Brocade BigIron RX Series Configuration Guide - Manual (Page 540)

462 BigIron RX Series Configuration Guide
53-1002484-04
VRRP and VRRPE parameters
17
Similarly, Router2 is the master for VRID 2 (backup priority = 110) and Router1 is the backup for
VRID 2 (backup priority = 100). Router1 and Router2 are both tracking the uplinks to the Internet.
If an uplink failure occurs on Router2, its backup priority is decremented by 20 (track priority = 20),
so that all traffic destined to the internet is sent through Router1 instead.
The BigIron RX device configured for VRRPE can interoperate only with other BigIron RX devices.
VRRP and VRRPE parameters
Table 93 lists the VRRP and VRRPE parameters. Most of the parameters and default values are the
same for both protocols. The exceptions are noted in the table.
TABLE 93 VRRP and VRRPE parameters
Parameter Description Default See page...
Protocol The Virtual Router Redundancy Protocol (VRRP) based on RFC
2338 or VRRP-Extended, Brocade’s enhanced implementation of
VRRP Disabled
NOTE: Only one of the
protocols can be
enabled at a time.
page 464
page 466
VRRP or VRRPE
router The device’s active participation as a VRRP or VRRPE router.
Enabling the protocol does not activate the device for VRRP or
VRRPE. You must activate the device as a VRRP or VRRPE router
after you configure the VRRP or VRRPE parameters. Inactive page 464
page 466
Virtual Router ID
(VRID) The ID of the virtual router you are creating by configuring multiple
routers to back up an IP interface. You must configure the same
VRID on each router that you want to use to back up the address.
No default. None page 464
page 466
Virtual Router IP
address This is the address you are backing up.
No default.
•
VRRP – The virtual router IP address must be a real IP
address configured on the VRID interface on one of the VRRP
routers. This router is the IP address Owner and is the
default Master.
•
VRRPE – The virtual router IP address must be in the same
subnet as a real IP address configured on the VRRPE
interface, but cannot be the same as a real IP address
configured on the interface.
None page 464
page 466
VRID MAC address The source MAC address in VRRP or VRRPE packets sent from the
VRID interface, and the destination for packets sent to the VRID.
•
VRRP – A virtual MAC address defined as
00-00-5e-00-01-
< vrid>. The Master owns the Virtual MAC
address.
•
VRRPE – A virtual MAC address defined as
02-E0-52-
< hash-value>- < vrid>, where < hash-value> is a
two-octet hashed value for the IP address and < vrid> is the
VRID.
Not configurable page 458