Brocade BigIron RX Series Configuration Guide - Manual (Page 1547)

BigIron RX Series Configuration Guide 1469
53-1002484-04
LAG
E
LAG
UDLD
Commands See ...
lag < lag-name> static | dynamic | keep-alive “Creating a Link Aggregation Group (LAG)” on
page 241
ports ethernet < slot/port> [ to < slot/port> ] [ ethernet
< slot/port> ]
“Creating a Link Aggregation Group (LAG)” on
page 241
primary port < slot/port> “Configuring the primary port for a LAG” on page 242
trunk-threshold < number> “Specifying the trunk threshold for a trunk Group” on
page 243
lacp-port-priority < slot/port> < number> “Configuring LACP port priority” on page 243
lacp-timeout [long | short] “Configuring an LACP timeout” on page 243
deploy [ forced | passive ] “Deploying a LAG” on page 244
acl-mirror-port ethe-port-monitored [slot/port] |
named-port-monitored [name] “Configuring ACL-based mirroring” on page 245
disable ethernet [slot/port] | named [name] “Disabling ports within a LAG” on page 245
enable ethernet [slot/port] | named [name] “Enabling ports within a LAG” on page 246
monitor ethe-port-monitored [slot/port] |
named-port-monitored [name] ethernet [slot/port] [ input
| output | both ] “Monitoring an individual LAG port” on page 246
port-name < text> ethernet < slot>/ < portnum> “Assigning a name to a port within a LAG” on
page 246
sflow-forwarding ethernet [slot/port] | port-name [text] “Enabling sFlow forwarding on a port within a LAG” on
page 247
sflow-subsampling ethernet [slot/port] | port-name [text]
< num>
“Setting the sFlow sampling rate for a port within a
LAG”
on page 247
show lag < lag-name> [brief] [deployed] [dynamic]
[keep-alive] [static]
“Displaying LAG information” on page 247
show statistics [brief] lag [ < lag-name>] “Displaying LAG information” on page 247
threshold < number> “Specifying the trunk threshold for a trunk Group” on
page 243
Commands See ...
clear link-keepalive statistics “Clearing UDLD statistics” on page 286
link-keepalive ethernet < portnum> [ethernet < portnum>] “Configuring UDLD” on page 282
link-keepalive interval < num> “Changing the keepalive interval” on page 282
link-keepalive retries < num> “Changing the keepalive retries” on page 283
show interface brief “Displaying information for all ports” on page 283