Lldp configuration details – Brocade BigIron RX Series Configuration Guide User Manual
Page 357
BigIron RX Series Configuration Guide
279
53-1002484-04
Configuring LLDP
9
Syntax: show lldp neighbors detail [ports ethernet <slotnum/portnum> | all]
If you do not specify any ports or use the keyword all, by default, the report will show the LLDP
neighbor details for all ports.
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually.
LLDP configuration details
The show lldp local-info command displays the local information advertisements (TLVs) that will be
transmitted by the LLDP agent.
NOTE
The show lldp local-info output will vary based on LLDP configuration settings.
The following shows an example report.
A backslash (\) at the end of a line indicates that the text continues on the next line.
The fields in the above output are described in the individual TLV advertisement sections in this
chapter.
Syntax: show lldp local-info [ports ethernet <slot num/port num> | all]
If you do not specify any ports or use the keyword all, by default, the report will show the local
information advertisements for all ports.
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually.
This field...
Displays...
Neighbor
The source MAC address from which the packet was received, and the remaining TTL for the
neighbor entry.
BigIron RX# show lldp local-info ports ethernet 4/1
Local port: 4/1
+ Chassis ID (MAC address): 000c.dbfa.f900
+ Port ID (MAC address): 000c.dbfa.f900
+ Time to live: 120 seconds
+ System name : "RX8"
+ Port description : "10GigabitEthernet4/1"
+ System capabilities : bridge, router
Enabled capabilities: router
+ 802.3 MAC/PHY : auto-negotiation supported, but disabled
Operational MAU type : 10GigBaseSR
+ Link aggregation: not capable
+ Maximum frame size: 1522 octets
+ Port VLAN ID: 1
+ Management address (IPv4): 8.8.8.1