Brocade BigIron RX Series Configuration Guide - Manual (Page 338)

260 BigIron RX Series Configuration Guide
53-1002484-04
Syslog messages
9
Syslog messages
Syslog messages for LLDP provide management applications with information related to MIB data
consistency and general status. These Syslog messages correspond to the lldpRemTablesChange
SNMP notifications.
Web Management
Web Management Interface is not supported.
Configuring LLDP
This section describes how to enable and configure LLDP.
Table 64 lists the LLDP global-level tasks and the default behavior/value for each task.
Configuration notes and considerations
• LLDP is supported on Ethernet interfaces only.
• If a port is 802.1X-enabled, the transmission and reception of LLDP packets will only take
place while the port is authorized.
TABLE 64 LLDP global configuration tasks and default behavior / value
Global task Default behavior / value when LLDP is enabled
Enabling LLDP on a global basis Disabled
Specifying the maximum number of LLDP
neighbors per device Automatically set to 392 neighbors per device
Specifying the maximum number of LLDP
neighbors per port Automatically set to 4 neighbors per port
Enabling SNMP notifications and Syslog messages Disabled
Changing the minimum time between SNMP traps
and Syslog messages Automatically set to 2 seconds when SNMP notifications and
Syslog messages for LLDP are enabled
Enabling and disabling TLV advertisements When LLDP transmit is enabled, by default, the Brocade
device will automatically advertise LLDP capabilities, except
for the system description, VLAN name, and power-via-MDI
information, which may be configured by the system
administrator.
Also, if desired, you can disable the advertisement of
individual TLVs.
Changing the minimum time between LLDP
transmissions Automatically set to 2 seconds
Changing the interval between regular LLDP
transmissions Automatically set to 30 seconds
Changing the holdtime multiplier for transmit TTL Automatically set to 4
Changing the minimum time between port
reinitializations Automatically set to 2 seconds