Brocade BigIron RX Series Configuration Guide - Manual (Page 1415)

BigIron RX Series Configuration Guide 1337
53-1002484-04
Displaying OSPFv3 information
49
For example, to display the SPF tree for area 0, enter the following command at any level of the CLI.
Syntax: show ipv6 ospf spf tree area <area-id>
The tree keyword displays the SPF table.
The area <area-id> parameter specifies a particular area. You can specify the <area-id> in the
following formats:
• As an IPv4 address; for example, 192.168.1.1
• As a numerical value from 0 – 2,147,483,647
In this sample output, consider the SPF node with the router ID 223.223.223.223 to be the top
(root) of the tree and the local router. Consider all other layers of the tree (223.223.223.223:88
and 1.1.1.1:0) to be destinations in the network. Therefore, traffic destined from router
223.223.223.223 to router 1.1.1.1:0 must first traverse router 223.223.223.223:88.
TABLE 236 OSPFv3 SPF Table
This field... Displays...
Destination The destination of a route, which is identified by the following:
•
“R”, which indicates the destination is a router. “N”, which indicates the destination
is a network.
•
An SPF node’s router ID (IPv4 address). If the node is a child node, it is additionally
identified by an interface on which the node can be reached appended to the
router ID in the format
< router-id > : < interface-id > .
Bits A bit that indicates the capability of the Brocade device . The bit can be set to one of the
following:
•
B – The device is an area border router.
•
E – The device is an AS boundary router.
•
V – The device is a virtual link endpoint.
•
W – The device is a wildcard multicast receiver.
Options A 24-bit field that enables IPv6 OSPF routers to support the optional capabilities. When
set, the following bits indicate the following:
V6 – The router should be included in IPv6 routing calculations.
E – The router floods AS-external-LSAs as described in RFC 2740.
MC – The router forwards multicast packets as described in RFC 1586.
N – The router handles type 7 LSAs as described in RFC 1584.
R – The originator is an active router.
DC –The router handles demand circuits.
Cost The cost of traversing the SPF node to reach the destination.
Next hop The IPv6 address of the next hop-router.
Interface The router interface through which to access the next-hop router.
BigIron RX# show ipv6 ospf spf tree area 0
SPF tree for Area 0
+- 223.223.223.223 cost 0
+- 223.223.223.223:88 cost 1
+- 1.1.1.1:0 cost 1