Brocade BigIron RX Series Configuration Guide - Manual (Page 765)

BigIron RX Series Configuration Guide 687
53-1002484-04
Changing the Shortest Path Tree (SPT) threshold
24
v125 125.0.0.1 SM V2 Itself 1 None
v126 126.0.0.1 SM V2 Itself 1 None
v127 127.0.0.1 SM V2 Itself 1 None
l1 1.0.8.1 SM V2 Itself 1 None
This example displays the route precedence selection as multicast non-default, then unicast
non-default, then multicast default, and then unicast default.
BigIron RX(config-pim-router)#show ip pim sparse
Global PIM Sparse Mode Settings
Hello interval : 30 Neighbor timeout : 105
Bootstrap Msg interval: 60 Candidate-RP Advertisement interval: 60
Join/Prune interval : 60 SPT Threshold : 1
Inactivity interval : 180 SSM Enabled : No
Hardware Drop Enabled : Yes
Route Selection : mc-non-default uc-non-default mc-default uc-default
---------+----------------+----+---+----------------------+------+-------------+
Interface|Local |Mode|Ver| Designated Router |TTL |Multicast |
|Address | | |Address Port |Thresh|Boundary |
---------+----------------+----+---+----------------------+------+-------------+
v12 100.4.8.2 SM V2 Itself 1 None
v13 100.16.8.2 SM V2 Itself 1 None
v124 124.0.0.1 SM V2 Itself 1 None
v125 125.0.0.1 SM V2 Itself 1 None
v126 126.0.0.1 SM V2 Itself 1 None
v127 127.0.0.1 SM V2 Itself 1 None
l1 1.0.8.1 SM V2 Itself 1 None
Changing the Shortest Path Tree (SPT) threshold
In a typical PIM Sparse domain, there may be two or more paths from a DR (designated router) for
a multicast source to a PIM group receiver.
• Path through the RP – This is the path the BigIron RX uses the first time it receives traffic for a
PIM group. However, the path through the RP may not be the shortest path from the BigIron RX
to the receiver.
• Shortest Path – Each PIM Sparse router that is a DR for a multicast source calculates a
shortest path tree (SPT) to all the PIM Sparse group receivers within the domain, with the
BigIron RX itself as the root of the tree. The first time a BigIron RX is configured as a PIM router
and receives a packet for a PIM receiver, the BigIron RX sends the packet to the RP for the
group. The BigIron RX also calculates the SPT from itself to the receiver. The next time the
BigIron RX receives a PIM Sparse packet for the receiver, the BigIron RX sends the packet
toward the receiver using the shortest route, which may not pass through the RP.
By default, the device switches from the RP to the SPT after receiving the first packet for a given
PIM Sparse group. The BigIron RX maintains a separate counter for each PIM Sparse source-group
pair.
After the BigIron RX receives a packet for a given source-group pair, the BigIron RX starts a PIM
data timer for that source-group pair. If the BigIron RX does not receive another packet for the
source-group pair before the timer expires, it reverts to using the RP for the next packet received for
the source-group pair. In accordance with the PIM Sparse RFC’s recommendation, the timer is 210
seconds and is not configurable. The counter is reset to zero each time the BigIron RX receives a
packet for the source-group pair.