Displaying the mct cluster information, Displaying detailed cluster information – Brocade BigIron RX Series Configuration Guide User Manual

Page 625

Advertising
background image

BigIron RX Series Configuration Guide

547

53-1002484-04

Configuring MCT

20

If the keepalive VLAN is not configured and both the peers are up, then both the peers keep
forwarding the traffic independently.

Setting the keepalive timers and hold time for the peers

To specify the keepalive timers and hold time for the peers, enter the following command.

BigIron RX(config-cluster-TOR)# peer 1.1.1.1 timers keep-alive 40 hold-time 120

Syntax: [no] peer <peer-ip> timers keep-alive <keep-alive time> hold-time <hold-time>

The <peer-ip> variable specifies the IP address of the peer and must be in the same subnet as that
of cluster management interface.

The <keep-alive time> variable specifies the keepalive time and can take values from 0 through
21845. The default value is 30 seconds.

The <hold-time> variable specifies the hold time and can take values from 3 through 65535. The
default value is 90 seconds. The hold time must be at least three times the keepalive time.

Displaying the MCT cluster information

You can display the following information about the MCT cluster on the device:

Detailed cluster information

Cluster client reachability information

Cluster peer state information

Displaying detailed cluster information

To display detailed cluster information about the ICL, peer, and clients, enter the following
command.

BigIron RX# show cluster

Cluster CLUSTER-1 2000

===================

Rbridge Id: 35535, Session Vlan: 2001, Keep-Alive Vlan: 301

Cluster State: Deploy

Client Isolation Mode: Loose

Configured Member Vlan Range: 2 to 2000 2002 to 4090

Active Member Vlan Range: 2 to 3 21 to 148 201 404 to 445 501 to 508 2010 3511 to

3574 4021 to 4025 4051 4070 4080 4087 4090

ICL Info:

---------

Name Port Trunk

ICL-1 2/1 6

Peer Info:

----------

Peer IP: 1.1.1.1, Peer Rbridge Id: 1, ICL: ICL-1

KeepAlive Interval: 50 , Hold Time: 300, Fast Failover

Active Vlan Range: 2 to 3 21 to 148 201 404 to 445 501 to 508 2010 3511 to 3574

4021 to 4025 4051 4070 4080 4087 4090

Peer State: CCP Up (Up Time: 0 days:19 hr:24 min: 8 sec)

Client Info:

Advertising