Brocade BigIron RX Series Configuration Guide - Manual (Page 1321)

BigIron RX Series Configuration Guide 1243
53-1002484-04
Displaying BGP4+ information
46
Displaying the BGP4+ running configuration
To view the active BGP4+ configuration information contained in the running configuration without
displaying the entire running configuration, enter the following command at any level of the CLI.
Syntax: show ipv6 bgp config
Displaying dampened BGP4+ paths
To display BGP4+ paths that have been dampened (suppressed) by route flap dampening, enter
the following command at any level of the CLI.
Syntax: show ipv6 bgp dampened-paths
This display shows the following information:
BigIron RX# show ipv6 bgp config
Current BGP configuration:
router bgp
local-as 1000
neighbor peer_group1 peer-group
neighbor 2001:4383:e0ff:783a::3 remote-as 1001
neighbor 2001:4484:edd3:8389::1 remote-as 1002
neighbor 2001:efff:80::23 peer-group peer_group1
neighbor 2001:efff:80::23 remote-as 1003
address-family ipv4 unicast
no neighbor 2001:4383:e0ff:783a::3 activate
no neighbor 2001:4484:edd3:8389::1 activate
no neighbor 2001:efff:80::23 activate
exit-address-family
address-family ipv4 multicast
exit-address-family
address-family ipv6 unicast
network 3ff0:ec21::/32
neighbor peer_group1 activate
neighbor 2001:4484:edd3:8389::1 activate
exit-address-family
end
BigIron RX# show ipv6 bgp dampened-paths
Status Code
>
:best d:damped h:history *:valid
Network From Flaps Since Reuse Path
*d 8::/13 2000:1:1::1 1 0 :1 :14 0 :2 :20 100 1002 1000
*d 1::/16 2000:1:1::1 1 0 :1 :14 0 :2 :20 100 1002 1000
*d 4::/14 2000:1:1::1 1 0 :1 :14 0 :2 :20 100 1002 1000
*d 2::/15 2000:1:1::1 1 0 :1 :14 0 :2 :20 100 1002 1000
*d 0:8000::/17 2000:1:1::1 1 0 :1 :14 0 :2 :20 100 1002 1000
*d 2000:1:17::/642000:1:1::1 1 0 :1 :18 0 :2 :20 100