Brocade BigIron RX Series Configuration Guide - Manual (Page 715)

BigIron RX Series Configuration Guide 637
53-1002484-04
ACL accounting
22
The display shows the following information.
Syntax: show access-list accounting brief
Displaying statistics for an interface
To display statistics for an interface, enter commands such as the following.
The display shows the following information.
This field... Displays...
The IP multicast traffic snooping state The first line of the display indicates whether IP multicast traffic
snooping is enabled or disabled. If enabled, it indicates if the feature is
configured as passive or active.
Collecting ACL accounting summary for
< interface>
Shows for which interfaces the ACL accounting information was
collected and whether or not the collection was successful.
Int The ID of the interface for which the statistics are being reported.
In ACL The ID of the ACL used to filter the incoming traffic on the interface.
Total In Hit* The number of hits from incoming traffic processed by all ACL entries
(filters) in the ACL. A number is shown for each counter.
* The Total In Hit displays the total number of hits for all the ACL entries (or filters) in an ACL. For example, if an
ACL has five entries and each entry processed matching conditions three times during the last minute, then the
total Hits for the 1m counter is 15.
BigIron RX(config)#show access-list accounting brief
Collecting ACL accounting summary for VE 1 ... Completed successfully.
ACL Accounting Summary: (ac = accumulated since accounting started)
Int In ACL Total In Hit
VE 1 111 473963(1s)
25540391(1m)
87014178(5m)
112554569(ac)
BigIron RX(config)#show access-list accounting ve 1 in
Collecting ACL accounting for VE 1 ... Completed successfully.
ACL Accounting Information:
Inbound: ACL 111
1: deny tcp any any
Hit count: (1 sec) 237000 (1 min)12502822
(5 min) 87014178 (accum) 99517000
3: permit ip any any
Hit count: (1 sec) 236961 (1 min) 13037569
(5 min) 0 (accum) 13037569
0: deny tcp 1.1.1.0 0.0.0.255 2.2.2.0 0.0.0.255
Hit count: (1 sec) 0 (1 min) 0
(5 min) 0 (accum) 0
2: deny udp any any
Hit count: (1 sec) 0 (1 min) 0
(5 min) 0 (accum) 0