Brocade BigIron RX Series Configuration Guide - Manual (Page 1515)

BigIron RX Series Configuration Guide 1437
53-1002484-04
IPv6 OSPFv3
E
IPv6 OSPFv3
poison-local-routes “Configuring poison reverse parameters” on
page 1214
poison-reverse “Configuring poison reverse parameters” on
page 1214
redistribute bgp | connected | isis | ospf | static [metric
< number>]
“Redistributing routes into RIPng” on page 1213
show ipv6 rip “Displaying RIPng configuration” on page 1215
show ipv6 rip route [ < ipv6-prefix>/ < prefix-length> |
< ipv6-address>]
“Displaying RIPng routing table” on page 1216
timers < update-timer> < timeout-timer>
< hold-down-timer> < garbage-collection-timer>
“Configuring RIPng timers” on page 1210
Commands See ...
Commands See ...
area < number> | < ipv4-address> “Assigning OSPFv3 areas” on page 1303
area < number> | < ipv4-address> stub < metric>
[no-summary]
“Assigning a totally stubby area” on page 1304
area < number> | < ipv4-address> virtual-link < router-id> “Configuring virtual links” on page 1305
area < number> | < ipv4-address> virtual-link < router-id>
[dead-interval < seconds> | hello-interval < seconds> |
retransmit-interval < seconds> | transmit-delay
< seconds>]
“Modifying virtual link parameters” on page 1306
auto-cost reference-bandwidth < number> “Changing the reference bandwidth for the cost on
OSPFv3 interfaces”
on page 1307
auto-cost reference-bandwidth < number> “Modifying exit overflow interval” on page 1318
default-information-originate [always] [metric < value>]
[metric-type < type>]
“Configuring default route origination” on page 1315
default-metric < number> “Modifying default metric for routes redistributed into
OSPF version 3”
on page 1310
distance external | inter-area | intra-area < distance> “Configuring administrative distance based on route
type”
on page 1317
distribute-list prefix-list < name> in [ < interface>] “Configuring an OSPFv3 distribution list using an IPv6
prefix list as input”
on page 1313
distribute-list route-map < name> in “Configuring an OSPFv3 distribution list using an IPv6
prefix list as input”
on page 1313
external-lsdb-limit < entries> “Modifying external link state database limit” on
page 1318
ipv6 ospf area < number> | < ipv4-address> “Assigning interfaces to an area” on page 1305
ipv6 prefix-list < name> [seq < seq-value>] [description
< string>] deny | permit < ipv6-addr>/ < mask-bits> [ge
< ge-value>] [le < le-value>]
“Configuring an OSPFv3 distribution list using a route
map as input”
on page 1314