Brocade BigIron RX Series Configuration Guide - Manual (Page 668)

590 BigIron RX Series Configuration Guide
53-1002484-04
Configuring Layer 2 ACLs
21
BigIron RX(config)# access-list 400 permit any any
BigIron RX(config)# access-list 400 permit any any log-enable
BigIron RX(config)# access-list 400 permit any any 100
BigIron RX(config)# access-list 400 permit any any 100 log-enable
BigIron RX(config)# access-list 400 permit any any any
BigIron RX(config)# access-list 400 permit any any any log-enable
BigIron RX(config)# access-list 400 permit any any 100 etype ipv4
BigIron RX(config)# access-list 400 permit any any 100 etype ipv4 log-enable
The following shows an example of a valid Layer 2 ACL clause.
BigIron RX(config)# access-list 400 permit any any 100 etype ipv4
Inserting and deleting Layer 2 ACL clauses
You can make changes to the Layer 2 ACL table definitions without unbinding and rebinding the
table from an interface. For example, you can add a new clause to the ACL table, delete a clause
from the table, delete the ACL table, etc.
Binding a Layer 2 ACL table to an interface
To enable Layer 2 ACL filtering, bind the Layer 2 ACL table to an interface.
NOTE
Layer 2 ACLs cannot be bound to virtual routing interfaces.
Enter a command such as the following at the Interface level of the CLI.
BigIron RX(config)# interface ethernet 4/12
BigIron RX(config-int-e100-4/12)# mac access-group 400 in
Syntax: [no] mac access-group <num> in
The <num> parameter specifies the Layer 2 ACL table ID to bind to the interface.
Increasing the maximum number of clauses per
Layer 2 ACL table
You can increase the maximum number of clauses configurable within a Layer 2 ACL table. You
can specify a maximum of 256 clauses per table. The default value is 64 clauses per table.
To increase the maximum number of clauses per Layer 2 ACL table, enter a command such as the
following at the Global CONFIG level of the CLI.
BigIron RX(config)# system-max l2-acl-table-entries 200
Syntax: system-max l2-acl-table-entries <max>
The <max> parameter specifies the maximum number of clauses per Layer 2 ACL. Enter a value
from 64 to 256.