Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 1066)

Brocade Network Advisor SAN User Manual 1019
53-1002948-01
Provisioning flows
30
Select products and ports under the Available Products panel and move to the Selected
Products panel using the right arrow. In the Selected Products panel you can select to Use
Any Port (*) in these products or Use Selected Ports. If you choose to use selected ports,
select a specific port under the Selected Products panel.
Move products and ports from the Selected Products panel back to the Available Products
panel by selecting them and using the left arrow.
Selecting OK on the Select Device Ports dialog box enters selected product WWNs or port
addresses into the Source and Destination fields on the Add Flow Definition dialog box.
3. On the Add Flow Definition dialog box, select <swap> if you want to swap source and
destination device identifications.
4. Select Port (slot/port) or D,I format.(domain ID, port number) for entering Switch Ingress and
Egress identification.
5. Use the following options to enter identification in the Switch Ingress and Egress fields.
- Type identifiers in the fields (entering an asterisk denotes any port) into the fields.
- Click the ellipsis button to the right of the Ingress and Egress fields to display the Select
Switch Ports dialog box (
Figure 435 ). Use this dialog box to select switch ports from
discovered fabrics.
FIGURE 435 Select Switch Ports dialog box.
On the Select Switch Ports dialog box, select a port in the Available Products panel and
move it under the Selected Products panel with the right arrow.
Select OK to close the Select Switch Ports dialog box and return to the Add Flow Definition
dialog box.
- Select <swap> to swap the Ingress switch identification and Egress switch identification.
6. If a target switch is not entered for the flow definition, select the ellipses button to the right of
the Target Switch field. The Select Targets dialog box displays.