Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 1166)

Brocade Network Advisor SAN User Manual 1119
53-1002948-01
Event action definitions
33
8. Click the Collect support save check box to enable SupportSave on the event. The check box is
unselected by default.
9. Click Next to display the Action Group - E-mail Settings pane of the Add Event Action dialog box
if you selected Alert by E-mail. If you did not select Alert by E-mail, you will advance to the
Summary pane.
Special events handling
The following special error conditions are examples of events that are categorized as Special
Events Handling events, a separate category that appears in the Name list of the Event Actions
dialog box. All pre-selected events are SNMP traps.
• Invalid T1 zone configuration event
• 48-blade inserted into a non-Virtual Fabric chassis
• Port fencing Fabric Watch trap, when a port is fenced
• Blade Processor FPGA version is incompatible with the Fabric OS firmware version
Though these error conditions are automatically considered “special events handling” events, you
can add or edit any event action and mark the action as a special event for special events handling
using the Actions pane of the Edit Event Action dialog box.
See step 7 of “Editing event actions” on page 1117 for information on enabling special events
handling for an event using the Actions pane of the Edit Event Action dialog box.
Acknowledging special events
When the Management application receives and processes events selected as special events, the
following status bar icon displays:
FIGURE 474 Status bar with highlighted special events icon
To configure special event acknowledgements, complete the following steps.
1. Click the special events icon to launch the Special Events dialog box, shown in Figure 475 .
The Special Events dialog box, shown in Figure 475 , lists the most recent 1000 events that
have been identified as special events.