Viewing password policy violators, Assigning roles and aors to an ad group – Brocade Network Advisor SAN User Manual v12.1.0 User Manual
Page 206
156
Brocade Network Advisor SAN User Manual
53-1002948-01
Authentication Server Groups authorization on the Management server
6
10. Click Yes on the confirmation message.
11. Click Close to close the Users dialog box.
Viewing password policy violators
To view password policy violators, complete the following steps.
1. Select Server > Users.
The Users dialog box displays.
2. Click the Policy tab.
3. Click View Policy Violators.
The View Policy Violators dialog box displays.
4. Review the password policy violator details.
The View Policy Violators dialog box includes the following details:
•
User ID — Displays the identifier of the user who violated the password policy.
•
Full Name — Displays the full name of the user who violated the password policy.
•
Reason — Displays the reason the user violated the password policy.
5. Click Close on the View Policy Violators dialog box.
6. Click Close on the Users dialog box.
Authentication Server Groups authorization on the Management
server
NOTE
You must have User Management Read and Write privileges to map roles and AORs to Active
Directory (AD) groups.
NOTE
You must configure an Lightweight Directory Access Protocol (LDAP) server as the primary
authentication server and set Authentication Server Groups as the authorization preference (refer
to
“Configuring LDAP server authentication”
Authentication Server Groups authorization enables you to configure user access rights to AD
groups (including users, contacts, computers, and other AD groups) by assigning roles and AORs to
groups in the Management application. LDAP provides user authentication and authorization using
the AD service in conjunction with LDAP on the switch.
Assigning roles and AORs to an AD group
Using Authentication Server Groups authentication, you assign users to groups within the LDAP
server, and assign roles and AORs to the groups within the Management application.
To assign roles and AORs to an AD group, complete the following steps.